Beko CTB6254 User Manual - Page 13
Anti-grease/active charcoal filters, saturation, 2 Lighting, Light Replacement
![]() |
View all Beko CTB6254 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4 Operating your appliance Commands luminous (Fig.11) the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes (*) If your appliance has the INTENSIVE speed function, from speed THREE, press key E for 2 seconds and it will be activated for 10 minutes after which it will return to the previously set speed. When the function is active the LED flashes. To interrupt it before the 10 minutes have elapsed, press key E again. Some models allow activating this function even with speed one and two. By pressing key F for two seconds (with the hood switched off) the "clean air" function is activated. This function switches the appliance on for ten minutes every hour at the first speed. As soon as this function is activated the motor starts up at the first speed for ten minutes. During this time key F and key C must flash at the same time. After ten minutes the motor switches off and the LED of key F remains switched on with a fixed light until the motor starts up again at the first speed after fifty minutes and keys F and C start to flash again for ten minutes and so on. By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e.g. if key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. By pressing key B the function is deactivated). (*) The "AUTOMATIC STOP TIMER" delays stopping of the hood, which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. Anti-grease/active charcoal filters saturation: •• When the A key flashes with a 2 second frequency the anti-grease filters must be washed. •• When the A key flashes with a 0.5 second frequency the active carbon filters must be replaced or washed depending on the type of filter. Once the clean filter has been put back one must reset the electronic memory by pressing the A key for approximately 5 seconds until it stops flashing. 4.2 Lighting Light Replacement 28W light • Remove the metal grease filters. • Unscrew the bulbs and replace them with new ones having the same characteristics. • Replace the metal grease filters. Cooker Hood / User Manual 13 / 14 EN
![](/manual_guide/products/beko-ctb6254-user-manual-c7d4e9d/13.png)