Beko CTB6254 User Manual - Page 9

3 Installing your appliance 3.1 Electric connection •• The appliance has been manufactured as a class II, therefore no earth cable is necessary. The electrical connection point must be easily accessible after the installation of the appliance. A suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be fitted between the appliance and the electricity supply in compliance with the load and current regulations. •• The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral. •• This device must be hardwired to the mains supply network by connecting to a single phase spur protected by a 3A fuse. •• The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.4) so that the unit is easier to handle. Cooker Hood / User Manual 9 / 14 EN