Beko CXFD6113 User Manual - Page 8

3 Installation BPlease remember that the 3. Clean the interior of the refrigerator as manufacturer shall not be held liable if recommended in the "Maintenance the information given in the instruction and cleaning" section. manual is not observed. 4. Plug the refrigerator into the wall Points to be considered when re-transporting your refrigerator outlet. When the fridge door is open, the fridge compartment interior light will come on. 5. You will hear a noise as the 1. Your refrigerator must be compressor starts up. The liquid and emptied and cleaned prior to any gases sealed within the refrigeration transportation. system may also give rise to noise, 2. Shelves, accessories, crisper and etc. even if the compressor is not running in your refrigerator must be fastened and this is quite normal. securely by adhesive tape against any 6. Front edges of the refrigerator may jolt before repackaging. feel warm. This is normal. These 3. Packaging must be adequate and areas are designed to be warm to the rules of transportation printed on avoid condensation the package must be followed. Please do not forget... Every recycled material is an indispensable source for the nature and for our national resources. If you wish to contribute to recycling Electric connection Connect your product to a grounded socket which is being protected by a fuse with the appropriate capacity. Important: the packaging materials, you can • The connection must be in get further information from the compliance with national regulations. environmental bodies or local • The power cable plug must be easily authorities. accessible after installation. Before operating your refrigerator • The specified voltage must be equal to your mains voltage. • Extension cables and multiway plugs Before starting to use your refrigerator must not be used for connection. check the following: 1. Is the interior of the refrigerator dry and can the air circulate freely in the rear of it? 2. Please install the 2 plastic wedges as illustrated in the figure. Plastic BA damaged power cable must be replaced by a qualified electrician. BProduct must not be operated before it is repaired! There is danger of electric shock! wedges will provide the required distance between your refrigerator and the wall in order to allow the air circulation. (The illustrated figure is only an example and does not match exactly with your product.) 7 EN