Beko DCU8230 User Manual - Page 6

2 Important safety instructions This section includes safety information that supplied with the product. If it is not will help protection from risks of personal compatible with the socket, have a injuries or materialistic damages. Failure qualified electrician change the socket to follow these instructions shall cause with a suitable one. any warranty and reliability commitment to • Items cleaned or washed with gasoil/ become void. fuel oil, dry-laundry solvents and other General safety combustible or explosive materials as • Never place the machine on a carpet- well as the items that are contaminated covered floor, otherwise, lack of airflow or spotted with such materials should beneath the machine may cause not be dried in the product since they electrical parts to overheat. This will emit flammable or explosive vapor. cause problems with your machine. • Do not dry items cleaned with industrial • If the power cable or mains plug is chemicals in the dryer. damaged, you must call Authorised • Do not dry unwashed items in the dryer. Service Agent for repair. • Items soiled with cooking oils, acetone, • The product should not be plugged alcohol, fuel oil, kerosene, stain remover, in during installation, maintenance turpentine, paraffin and paraffin removers and repair works. Such works should must be washed in hot water with plenty always be made by the technical of detergent before being dried in the service. Manufacturer shall not be held dryer. responsible for damages arising from • Garments or pillows bolstered with processes carried out by unauthorised rubber foam (latex foam), shower persons. bonnets, water resistant textiles, • Connect the product to a grounded materials with rubber reinforcement and outlet protected by a fuse of suitable rubber foam pads should not be dried in capacity as stated in the technical the dryer. specifications table. • Do not use fabric softeners and • Operate your product at temperatures anti-static products unless they are between +5°C and +35°C. recommended by the manufacturers of • Do not use electrical devices in the the fabric softener or the product. product. • This product must be earthed. • Do not connect the air exit of the product Grounding installation decreases the risk to the chimney holes which are used of electric shock by opening a path with for the exhaust fumes of the devices low resistance for the electricity flow in operating with gas or other types of fuel. case of a malfunction or failure. Power • You must provide enough ventilation cable of this product is equipped with in order to prevent gases exiting from a conductor and a grounding plug that devices operating with other types of allows for grounding the product. This fuels including the naked flame from plug must be installed appropriately and accumulating in the room due to the inserted into a socket which is grounded back fire effect. in accordance with the local laws and • Always clean the lint filter before or after regulations. each loading. • Do not install the product behind a door • Never operate your dryer without the lint with a lock, sliding door or a door that filter installed. has a hinge against the hinge of the • Do not allow fibre, dust and dirt dryer. accumulation around the exhaust exit • Do not install or leave this product and at adjacent areas. in places where it will be exposed to • Power cable plug must be within easy outdoor conditions. reach after installation. • Do not tamper with the controls. • Do not use extension cords, multi-plugs • Do not perform any repair or part or adaptors to connect the dryer to replacing procedures on the product power supply in order to decrease the even if you know or have the ability to risk of electric shock. perform unless it is clearly suggested • Do not make any changes on the plug in the operating instructions or the 6 EN