Beko DFN04210 User Manual - Page 15

Preparation a b 1 min. c d 1 Second e f 1 Minute Remove the test Turn on the tap and Hold the test strip in Remove the test Wait for 1 minute. The test strip shows strip from the let the water run for the water for about strip from the water you the hardness packet. about a minute. a second. and shake it. level. After determining hardness level of the supply water: 1. When the Programme Selection key is at "Off" position, keep Start/Pause/Cancel key pressed and turn the Programme Selection key to position "1" within 5 seconds. Machine will enter into the regeneration adjustment mode at the end of this period. 2. Regeneration level in the memory will be illuminated for 5 seconds when the regenerator adjustment mode is activated. 3. To adjust the new Water Hardness Level, move the Programme Selection key to the position that is suitable for your supply water. (see, "Water Hardness Level Adjustment Table") 4. Press Start/Pause/Cancel key for once to store the level you have selected. Machine returns to the normal operating mode after the new setting is stored. * Programme Selection key rotates in 5 steps regardless of the number of the programmes contained on the machine. 5. Press "Start/Pause/Cancel" key for once to store the level you have selected. Water hardness level adjustment table Hardness Level 0th Level 1st Level 2nd Level 3rd Level English Water Hardness °dE German Water Hardness °dH French Water Hardness °dF Position of Program Water Hardness Level Indicator Selection Key* 0-5 0-4 0-8 1 6-9 5-7 9-13 1 Washing lamp on the panel will illuminate. 10-15 8-12 14-22 2 Drying lamp on the panel will illuminate. 16-19 13-15 23-27 3 End lamp on the panel will illuminate. 4th Level 20-24 16-19 28-34 4 5th Level 25-62 20-50 35-90 5 Washing, Drying and End lamps on the panel will illuminate. Washing, Drying and End lamps on the panel will flash with an interval of 1 second. If the hardness level of the supply water is above 90 °dF or if you are using well water, then it is recommended to use water purification devices and special filters. If the hardness level of the supply water is below 13°dF, there is no need to use salt in your dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates continuously on the panel of your machine. Dishwasher / User's Manual 13/36 EN