Beko DFS05X10 User Manual - Page 15

Detergent, Add²ng detergent

Page 15 highlights

Preparation If the hardness level of the water that you use is above 80 °dF (French standard for water hardness) or if you are using well water, then it is recommended to use filter and water purification devices. If the hardness level of the water that you use is below 8°dF (French standard for water hardness), there is no need to use salt in your dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates continuously on the panel of your machine. If the water hardness adjustment is set to level 1, the "No salt warning indicator" will illuminate continuously although it is not necessary to use salt. If you use salt under this condition, salt will not be consumed and the lamp will not illuminate. C Since different salt brands in the market have different particle sizes and since the water hardness may vary, dissolution of the salt in water may take a couple of hours. Therefore, Salt Indicator remains on for a while after adding salt into the machine. Loose salt grains can cause rust marks in your machine if not rinsed away. Only fill salt just before a programme is run. C Contact the detergent producer if the dishes are wet and/or if you notice limescale spots particularly on glasses after the washing programme is over. Adding detergent C Refer to the "Programme Table" to determine the correct amount of detergent for the selected programme. A Do not put solvents into the detergent dispenser. There is the risk of explosion! Put the detergent into the detergent dispenser just before operating the machine as illustrated below. 1. Push the latch to right to open the detergent dispenser lid (A). A Detergent You can use powder or tablet detergent in the machine. C Only use in the machine the detergents produced particularly for use with dishwashers. We recommend you not to use detergents that contain chlorine and phosphate as they are harmful for the environment. Dishwasher / User's Manual 2. Put suggested amount of powder or tablet detergent in the dispenser. 25cm³ 15cm³ 1 2 5cm³ 15/34 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34

D±shwasher / User’s Manual
15
/
34
EN
Preparation
C
Since different salt brands
in the market have different
particle sizes and since the
water hardness may vary,
dissolution of the salt in water
may take a couple of hours.
Therefore, Salt Indicator
remains on for a while after
adding salt into the machine.
Loose salt grains can cause rust
marks in your machine if not
rinsed away. Only fill salt just
before a programme is run.
Detergent
You can use powder or tablet detergent in
the machine.
C
Only use in the machine
the detergents produced
particularly for use with
dishwashers. We recommend
you not to use detergents that
contain chlorine and phosphate
as they are harmful for the
environment.
C
Contact the detergent producer
if the dishes are wet and/or
if you notice limescale spots
particularly on glasses after the
washing programme is over.
Add²ng detergent
C
Refer to the “Programme
Table” to determine the correct
amount of detergent for the
selected programme.
A
Do not put solvents into the
detergent dispenser. There is
the risk of explosion!
Put the detergent into the detergent
dispenser just before operating the
machine as illustrated below.
1.
Push the latch to right to open the
detergent dispenser lid (A).
°
2.
Put suggested amount of powder or
tablet detergent in the dispenser.
If the hardness level of the water that you
use is above 80 °dF (French standard for
water hardness) or if you are using well
water, then it is recommended to use filter
and water purification devices.
If the hardness level of the water that you
use is below 8°dF (French standard for
water hardness), there is no need to use salt
in your dishwasher. If this is the case, “No
Salt Warning Indicator” (if any) illuminates
continuously on the panel of your machine.
If the water hardness adjustment is set to
level 1, the “No salt warning indicator” will
illuminate continuously although it is not
necessary to use salt. If you use salt under
this condition, salt will not be consumed and
the lamp will not illuminate.