Beko HNCC64105 User Manual - Page 11
Installation, connection - ceramic hob
View all Beko HNCC64105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation and connection • Product can only be installed and connected in accordance with the statutory installation rules. Do not install the hob on places with sharp edges or corners. here is the risk of breaking for glass ceramic surface! Electrical connection Connect the product to a grounded outlet/line protected by a fuse of suitable capacity as stated in the "Technical specifications" table. Have the grounding installation made by a qualified electrician while using the product with or without a transformer. Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations. "DANGER: I • The product must be connected to the mains supply only by an authorised and qualified person. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. DANGER: The power cable must not be clamped, bent or trapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! • Connection must comply with national regulations. • The mains supply data must correspond to the data specified on the type label of the product. Type label is at the rear housing of the product. • Power cable of your product must comply with the values in "Technical specifications" table. "DANGER: • Before starting any work on the electrical installation, disconnect the product from the mains supply. There is the risk of electric shock! Connecting the power cable 1. If a power cable is not supplied together with your product, a power cable that you would select from the table in accordance with the electrical installation at your home must be connected to your product by following the instructions in cable diagram. This product must only be connected by a qualified electrician such as a technician from the local electricity company or NICEIC registered contractor to a suitable double-pole control unit with a minimum contact clearance of 3 mm in all poles. This control unit must be installed accordance with the IEE regulation. Failure to obey this instruction may cause operational problems and invalidate the product warranty. dditional protection by a residual urrent circuit breaker is ecommended. 2. Open the terminal block cover with a screwdriver. 3. Insert the power cable through the cable clamp below the terminal and secure it to the main body with the integrated screw on cable clamping component. 4. Connect the cables according to the supplied diagram. 3 4 4 2 2 PP uP t CORD 6 5M.5mm 4 400V2N 3XL5mm 4 230V- 5. After completing the wire connections, close the terminal block cover. 6. Route the power cable so that it will not contact the product and get squeezed between the product and the wall. Power cable must not be longer than 2m because of safety reasons. 11/EN