Beko HQAW75225S User Manual - Page 14
conversion
View all Beko HQAW75225S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
For example, if it is possible to touch the bottom of the product since it is installed onto a drawer, this section must he covered with a wooden plate. \\_\\NN. min. 15 mm Rear view (connection holes) Gas conversion . DANGER: AI • Before starting any work on the gas installation, disconnect the gas supply. There is the risk of explosion! In order to change your appliance's gas type, change all injectors and make flame adjustment for all valves at reduced flow rate position. Exchange of injector for the burners 1. Take off burner cap and burner body. 2. Unscrew injectors by turning the counter- clockwise. 3. Fit new injectors. 4. Check all connections for secure fitting and tightness. New injectors have their position marked on their packing or injector table on Injector table, page 10 can be referred to. Place the burner plates, burner plate caps and grills back to their seating after installation. . DANGER: AI • Making connections to different holes is not a good practice in terms of safety since it can damage the gas and electrical system. ADANGER: There are gas and electric components on hobs. Therefore stove, only the connection hole shown in this manual should only be fixed to the unit as shown in the manual using the supplied fasteners and screws supplied. Otherwise, it is dangerous to the life and property safety. Final check 1. Open gas supply. 2. Check gas installations for secure fitting and tightness. 3. Ignite burners and check appearance of the flame. Flame must be blue and have a regular shape. If the flame is yellowish, check if the burner cap is seated securely or clean the burner. ((Varies depending on the product model.)) On some hob burners, the injector is covered with a metal piece. This metal cover must be removed for injector replacement. 1 -2 -1 4 4 1 Flame failure device 2 Spark plug 3 Injector 4 Burner Unless there is an abnormal condition, do not attempt to remove the gas burner taps. You must call an Authorised service agent or technician with licence if it is necessary to change the taps. Reduced gas flow rate setting for hob taps 1. Ignite the burner that is to be adjusted and turn the knob to the reduced position. 2. Remove the knob from the gas tap. 1 4/EN