Beko HRI64401AT User Manual - Page 9

Installation P oduct must be installed by a qualified person in accordance with the regulations in force. The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorized persons which may also void the warranty. Preparation of location and electrical installation for the product is under AI, insta ler's responsibility. DANGER: •I The product must be installed in accordance with all local electrical regulations. I DANGER: A• V Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. Before installation The hob is designed for installation into commercially available work tops. A safety distance must be left between the appliance and the kitchen walls and furniture. See figure (values in mm). • It can also be used in a free standing position. Allow a minimum distance of 650 mm above the hob surface. • (*) If a cooker hood is to be installed above the cooker, refer to cooker hood manufacturer' instructions regarding installation height (min 650 mm) • Remove packaging materials and transport locks. • Surfaces, synthetic laminates and adhesives used must be heat resistant (100 °C minimum). • The worktop must be aligned and fixed horizontally. • Cut aperture for the hob in worktop as per installation dimensions. ** 400mm min 55mm min 4 mme,21„ 560mm 60mm min 50mm Mi Minimum height to extractor as recommend in extractor instruction manual Minimum distance between cabinetry must be equal to width of hob 9/EN