Beko WI1573 User Manual - Page 13

Installation 2. Adjust the feet until the product stands level and balanced. 100cm 40cm • To prevent flowing of dirty water back into the machine and to allow for easy discharge, do not immerse the hose end into the dirty water or do not drive it in the drain more than 15 cm. If it is too long, cut it short. • The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched between the drain and the machine. • If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak. 3.6 Adjusting the feet A warning: In order to ensure that the product operates more silently and vibrationfree, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause crushing and vibration problems. 1. Loosen the lock nuts on the feet by hand. 3. Tighten all lock nuts again by hand. A warning: Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged. 3.7 Electrical connection Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any damages that will arise when the product is used without grounding in accordance with the local regulations. • Connection must comply with national regulations. • Power cable plug must be within easy reach after installation. • If the current value of the fuse or breaker in the house is less than 13 Amps, have a qualified electrician install a 13 Amp fuse. • The voltage specified in the "Technical specifications" section must be equal to your mains voltage. • Do not make connections via extension cables or multi-plugs. B warning: Damaged power cables must be replaced by the Authorised Service Agents. Washing Machine /User's Manual 13 / EN