Beko WIY74545 Owners Manual - Page 39

Problem Reason Solution Loading door cannot be opened. Door lock is activated because of the water level • Drain the water by running the Pump in the machine. or Spin programme. Machine is heating up the water or it is at the spinning cycle. • Wait until the programme completes. Child lock is engaged. Door lock will be deactivated • Wait for a couple of minutes for a couple of minutes after the programme has deactivation of the door lock. come to an end. Loading door may be stuck because of the pressure it is subjected to. • Grab the handle and push and pull the loading door to release and open it. Washing takes longer time than specified in the manual.(*) Water pressure is low. • Machine waits until taking in adequate amount of water to prevent poor washing quality due to the decreased amount of water. Therefore, the washing time extends. Voltage might be low. • Washing time is prolonged to avoid poor washing results when the supply voltage is low. Input temperature of water might be low. • Required time to heat up the water extends in cold seasons. Also, washing time can be lengthened to avoid poor washing results. Number of rinses and/or amount of rinse water might have increased. • Machine increases the amount of rinse water when good rinsing is needed and adds an extra rinsing step if necessary. Excessive foam might have occurred and • Use recommended amount of automatic foam absorption system might have detergent. been activated due to too much detergent usage. Programme time does not Timer may stop during water intake. countdown. (On models with display) (*) • Timer indicator will not countdown until the machine takes in adequate amount of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer indicator will resume countdown after this. Timer may stop during heating step. • Timer indicator will not countdown until the machine reaches the selected temperature. Timer may stop during spinning step. • Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum. Programme time does not countdown. (*) There might be unbalanced load in the machine. • Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum. Machine does not switch to There might be unbalanced load in the machine. spinning step. (*) • Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum. The machine will not spin if water is not drained • Check the filter and the draining hose. completely. Excessive foam might have occurred and • Use recommended amount of automatic foam absorption system might have detergent. been activated due to too much detergent usage. Washing Machine / User's Manual 39 / EN