Beko WMB51021 User Manual - Page 9

3 Installation Refer to the nearest Authorised Service Agent for installation of the product. To make the product ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. C Preparation of the location and electrical, tap water and waste water installations at the place of installation is under customer's responsibility. B WARNING: Installation and electrical connections of the product must be carried out by the Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons. A WARNING: Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. C Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. 3.1 Appropriate installation location • Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces. • Total weight of the washing machine and the dryer -with full load- when they are placed on top of each other reaches to approx. 180 kilograms. Place the product on a solid and flat floor that has sufficient load carrying capacity! • Do not place the product on the power cable. • Do not install the product at places where temperature may fall below 0ºC. • Place the product at least 1 cm away from the edges of other furniture. 3.2 Removing packaging reinforcement Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. 3.3 Removing the transportation locks A WARNING: Do not remove the transportation locks before taking out the packaging reinforcement. A WARNING: Remove the transportation safety bolts before operating the washing machine! Otherwise, the product will be damaged. 1. Loosen all the bolts with a suitable spanner until they rotate freely (C). 2. Remove transportation safety bolts by turning them gently. Washing Machine / User's Manual 9 / 36 EN