Belkin F1DM216T User Manual - Page 28
from the MATRIX2. - firmware
View all Belkin F1DM216T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
USING YOUR MATRIX2 1. Once the above steps have been completed, run the flash software executable. Make sure that the appropriate Flash DIP switch is set to the "ON" position. Only one firmware can be "flashed" at one time. 2. After the flash update has been completed, unplug the power supply from the MATRIX2. 3. Set all DIP switches to the "OFF" position. 4. You are now ready to use your MATRIX2 or continue flashing a different component if necessary. 26
26
USING YOUR MATRIX2
1. Once the above steps have been completed, run the flash software
executable. Make sure that the appropriate Flash DIP switch is set to
the “ON” position. Only one firmware can be “flashed” at one time.
2.
After the flash update has been completed, unplug the power supply
from the MATRIX2.
3.
Set all DIP switches to the “OFF” position.
4.
You are now ready to use your MATRIX2 or continue flashing a
different component if necessary.