Belkin F6C150-RKM-2U Belkin OmniGuard Rackmount UPS Hardware Manual - Page 9
Product Diagnostics
View all Belkin F6C150-RKM-2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PRODUCT DIAGNOSTICS Turning the Unit On/Off ON/OFF/Test Switch Press and release the "ON/OFF/TEST" switch. After one beep the unit will turn on and supply power to the load. The load is immediately powered while the UPS runs a five-second selftest. Press and release the switch (after one beep)to turn the unit off. The UPS will continue to charge the batteries whenever it is plugged in and there is AC present. Self-Test ON/OFF/Test Switch The self-test feature is useful to verify the correct operation of the UPS and the condition of the batteries. With the UPS plugged into normal AC, press and hold the "ON/OFF/TEST" switch for four seconds (four beeps) then release the switch. The UPS will perform a 10-second self-test. Note: The UPS will automatically perform a self-test on start-up and every two weeks. During the self-test the UPS will switch to battery power, the On-Line LED will blink, and the audible alarm will sound as well. The length of the test that is automatically performed every two weeks is longer than the start-up or userinvoked test. This test will run for approximately 15 seconds to measure the battery capability to provide an acceptable amount of runtime. If the UPS fails a self-test, one of the LEDs will remain illuminated indicating the type of problem. PRODUCT DIAGNOSTICS DIP Switch Settings The DIP-switch setting may be changed by the user to set the desired inverter (on-battery) output voltage. The DIP switch must be set to the desired output voltage and then the unit must be turned OFF and restarted to reconfigure the microprocessor and save the change. The setting for the 120VAC units may be 110VAC, 120VAC, or 130VAC. This setting will adjust the inverter (on-battery) output voltage only. The setting for the 230VAC units may be 220VAC, 230VAC, and 240VAC. Switch #1 OFF ON OFF ON Switch #2 OFF OFF ON ON Output Voltage in Battery Mode (110VAC) (220VAC) (120VAC) (230VAC) (110VAC) (220VAC) (127VAC) (240VAC) CAUTION! When reconfiguring the DIP-switch settings, make certain that the output settings do NOT exceed the capacity of the connected equipment. 16 17