BenQ PB8140 User Manual - Page 19

Setting Up Your Projector, Choosing a Location, Making Connections

Get BenQ PB8140 - SVGA DLP Projector PDF manuals and user guides
UPC - 840046007362
View all BenQ PB8140 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Setting Up Your Projector Choosing a Location Your projector is designed to be installed in the four installation configurations shown here: Floor front, Ceiling front, Floor rear, Ceiling rear. Your room layout or personal preference will dictate which installation configuration you use. I. Floor front II. Ceiling front III. Floor rear IV. Ceiling rear For further information on the four configurations, please refer to page 31. If you place the projector above or below the screen, you have to tile it down or up to center the image on the screen, in these situations image distortion will occur. Use the Keystone function to correct the distortion. See page 20 for keystone correction. Making Connections When connecting a signal source to the projector, be sure to: 1. Turn all equipment off before making any connections. 2. Use the correct signal cables for each source. 3. Ensure the cables are firmly inserted. Setting Up Your Projector 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Setting Up Your Projector
13
Setting Up Your Projector
Choosing a Location
Your projector is designed to be installed in the four installation configurations shown here:
Floor front, Ceiling front, Floor rear, Ceiling rear. Your room layout or personal preference
will dictate which installation configuration you use.
For further information on the four configurations, please refer to page
31
.
If you place the projector above or below the screen, you have to tile it down or up to center
the image on the screen, in these situations image distortion will occur. Use the Keystone
function to correct the distortion. See page
20
for keystone correction.
Making Connections
When connecting a signal source to the projector, be sure to:
1.
Turn all equipment off before making any connections.
2.
Use the correct signal cables for each source.
3.
Ensure the cables are firmly inserted.
I. Floor front
II. Ceiling front
III. Floor rear
IV. Ceiling rear