BenQ TK800M User Manual - Page 41

8. Use the handle to slowly pull the lamp out of the projector. • Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector. • Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials. • Do not insert your hands into the projector after the lamp is removed. The sharp edges inside the projector may cause injuries. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images. 9. As shown in the figure, insert the new lamp. Align the lamp connector and 2 sharp points with the projector and push the lamp a bit into the locked position. 10. Insert the lamp connector. 11. Tighten the screw that secures the lamp. 12. Ensure the handle is fully laid flat and locked in place. • Loose screw may cause a bad connection, which could result in malfunction. • Do not over tighten the screw. 13. Stick the transparent protection film back in place. 14. Replace the lamp cover on the projector. 8 10 9 9 12 11 13 14 15. Tighten the screws that secure the lamp cover. 16. Connect the power and restart the projector. 15 15 Resetting the Light Usage Timer 17. After the startup logo, open the On-Screen Display (OSD) menu. Go to SYSTEM SETUP: ADVANCED > Light Settings and press OK. The LIGHT SETTINGS page appears. Highlight Reset Light Usage Timer and press OK. A warning message is displayed asking if you want to reset the lamp timer. Highlight Reset and press OK. The lamp time will be reset to "0". Do not reset if the lamp is not new or replaced as this could cause damage. Maintenance 41