Bernina 350PE User Guide - Page 12
Inserting a Bobbin, Winding a Bobbin
View all Bernina 350PE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 Preparation - Sewing Winding a Bobbin █ turn power switch on (to «I») █ place empty bobbin on spindle █ place thread on spool pin █ attach appropriate spool disc; diameter of thread spool determines disc size █ following the direction of the arrow take thread through the rear guide and round the pre-tension stud █ wind the thread two to three times around the empty bobbin and cut off any excess thread on the thread cutter █ push engaging lever against bobbin, the winder works automatically █ the motor will stop automatically when the bobbin is full Inserting a Bobbin Thread cutter █ pull thread over thread cutter when removing the bobbin Bobbin winding while sewing █ place thread spool on vertical spool pin then, following the direction of the arrow, take thread through the thread guide and around the pre-tension stud █ then proceed as mentioned above Insert the bobbin so that the thread runs clockwise. Laying the thread into the slot Pull the thread counter clockwise into the slot. Pulling the thread under the spring Pull the thread to the left under the spring until it lies in the T-shaped slit at the end of the spring. The bobbin must turn clockwise. 033301.70.04_1007_B330_B350_B380_EN