Binatone Speakeasy Combo 2005 User Guide - Page 34

10 TROUBLESHOOTING If you have difficulty with your phone, please try the suggestions listed below. Problem No dialling tone when pressing the key When connected to a PBX, no and/or wrong connection after dialling. "OUT OF RANGE" is displayed. The call does not work. No display. Cause a. The connection cord of the base station is not plugged in. b. The adapter cord is not plugged in correctly in the base station. c. The line is busy, as another handset is used. d. Wrong telephone line cord. Dialling prefix is needed. a. Base station out of range. b. Base station not connected to mains. Service not activated or wrong operator or wrong setting Empty battery Solutions a. Check the connections. Unplug and plug back in the mains. Check that the telephone line cord has been plugged into the base station and the phone socket. b. Check the base station plug and the 230V plug (remove and plug-in). c. Wait until the line is unoccupied. d. Use the original telephone line cord supplied. Insert the dialling prefix Reduce the range. Connect base station to mains. Check your Subscription with network or change the dial mode. Recharge battery Please contact the technical support of the network provider for further information. This telephone is not equipped with an earth function! Therefore some of the functions may be limited when used in PBX systems. If the fault persists: Disconnect all other instruments connected to the same line as this, and try to make a call. Disconnect the base unit from the telephone line and plug a different phone into the master socket. Try making a call. If this works the line is ok. If the call does not work, and you are using a two-way socket adapter, remove it and plug the telephone directly into the socket. If the call now works, the adapter may be faulty. m 32