Biostar IDEQ 210V iDEQ 210V user'smanual - Page 19
Jumpers, Headers, Connectors, Slots
View all Biostar IDEQ 210V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Chapter 2 2 23 Jumpers, Headers, Connectors and Slots The illustration shows how to set up jumpers. When the Jumper cap is placed on pins, the jumper is "close". IF no jumper cap Is placed on the pins, the jumper Is "open". The Illustration shows a 3-pin jumper whose piny and 2 are "close" when jumper cap is placed on these 2 pins. 74 4 Jumper open Jumper close Ple1-2 close Jumpers, leaders, Connectors and Slots • Floppy Disk Connector: FDD1 The motherboard provides a standard floppy disk connector that supports 3800, 720K, 1.2M, 1.14M and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon cables. • Nord Disk Connectors: IIIE1/ IIIE2 The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0-5, Bus Master, and Ultra DMA 33/ GB! 100/ 133 functionality.I1has twoIII connectors ME' (primary) and IDE2 (secondary). The IDE connectors can collect a master and a slave drive, so you can connect up to tour hard disk drives. The first hard drive should always be connected to ME'. • Peripheral Component Interconnect Slots: PCI 1 This motherboard is equipped with1standardPCI slots.PCI stands for Peripheral Compliment Interconnect, and it is a bus standard for expansion cards. This PCI slot is designated as 32 hits. • Accelerated Graphics Port Slot: AGP1 Your monitor will attach directly to that video card. This motherboard supports video cards for PCI slots, hut it is also equipped with an Accelerated Graphics Port (IMP). An AGP card will take advantage of AMP technology for improved video efficiency and performance, especially with MI graphics. 11