Biostar M7NCD PRO M7NCD Pro compatibility test report - Page 44
Vcore Ripple TestOpen up the DOS Editor
View all Biostar M7NCD PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
CPU CH1 Condition Vcore Ripple Test(Open up the DOS Editor) Athlon_XP_2800+ M\B NCD-Pro1.1 Vcore CH2 STP CLK 1.Boot the system to the Win98SE environment(Command Prompt Only) Dos mode and run the stpclk.bat 2.At the main menu ,type Enter & Enter & "Y" to go to the "menu" 3.At the next menu , select "Power Management Utilities4 4.At this menu , select "Throttle Ratio" and set at the rang of 50.0%~56.0% and set "Enable" of " ON" 5.Press tiwce and then "Y" to exit the stpclk.bat program. 6.Type "EDIT" to enter the "EDIT" pragram. Press "Alt+F" to open up a Pop-up menu. 7.Measure the Vcore waveform Vcore Transient waveform RESULT PASS 44
44
Vcore Ripple Test(Open up the DOS Editor)
CPU
Athlon_XP_2800+
M\B
NCD-Pro1.1
CH1
Vcore
CH2
STP CLK
Condition
1.Boot the system to the Win98SE environment(Command Prompt Only)
Dos mode and run the stpclk.bat
2.At the main menu ,type Enter & Enter & “Y”
to go to the “menu”
3.At the next menu , select “Power Management Utilities4
4.At this menu , select “Throttle Ratio”
and set at the rang of
50.0%~56.0%
and set “Enable”
of
“ ON”
5.Press <ESC> tiwce and then “Y” to exit the stpclk.bat program.
6.Type “EDIT” to enter the “EDIT” pragram. Press “Alt+F” to open up a
Pop-up menu.
7.Measure the Vcore waveform
Vcore Transient waveform
RESULT
PASS