Biostar M7VIT BRAVO M7VIT Bravo user's manual - Page 10

MM77VVIITT BBrraavvoo Jumpers, Headers, Connectors & Slots Floppy Disk Connector: FDD1 The motherboard provides a standard floppy disk connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon cables. Hard Disk Connectors: IDE1/ IDE2 The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0~4, Block Mode, Bus Master, and Ultra DMA 33/ 66/ 100/ 133 functionality. It has two HDD connectors IDE1 (primary) and IDE2 (secondary). The IDE connectors can connect a master and a slave drive, so you can connect up to four hard disk drives. The first hard drive should always be connected to IDE1. Peripheral Component Interconnect Slots: PCI 1-5 This motherboard is equipped with 5 standard PCI slots. PCI stands for Peripheral Component Interconnect, and it is a bus standard for expansion cards. This PCI slot is designated as 32 bits. Accelerated Graphics Port Slot: AGP1 Your monitor will attach directly to that video card. This motherboard supports video cards for PCI slots, but it is also equipped with an Accelerated Graphics Port (AGP). An AGP card will take advantage of AGP technology for improved video efficiency and performance, especially with 3D graphics. Serial ATA Connector: JSATA1/ JSATA2 (Optional) The motherboard has a PCI to SATA Controller with 2 channels SATA interface, it satisfies the SATA 1.0 spec and can transfer data with 1.5 Gb/s speed. 65 3 2 Pin Assignment Pin 1 Ground 2 Assignment TX+ 3 TX- 4 741 5 RX- 6 JSATA1/ JSATA2 7 Ground Ground RX+ Note: 1. When plugging SATA HDD on JSATA1 connector, SATA BIOS will automatically detect as channel 1. 2. When plugging SATA HDD on JSATA2 connector, SATA BIOS will automatically detect as channel 0. 8