Biostar M7VIZ M7VIZ BIOS setup guide - Page 14
The Choices: Auto By SPD - manual
View all Biostar M7VIZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
M7VIZ BIOS Setup DRAM Timing This item determines DRAM clock/ timing follow SPD or not. The Choices: Auto By SPD (default), Manual, Turbo, Ultra. DRAM CAS Latency When DRAM is installed, the number of clock cycles of CAS latency depends on the DRAM timing. The Choices: 2.5 (default), 2. Bank Interleave This item allows you to enable or disable the bank interleave feature. The Choices: Disabled (default), 2 bank, 4 bank. Precharge to Active (Trp) This items allows you to specify the delay from precharge command to activate command. The Choices: 2T, 3T, 4T, 5T (default). Tras Non DDR 400/ DDR 400 This item allows you to choose Non DDR 400/ DDR 400 The Choices: 6T/ 8T, 7T/10T (default), 5T/ 6T, 8T, 12T. Active to Precharge (Tras) This items allows you to specify the minimum bank active time. The Choices: 7T, 6T (default). Active to CMD (Trcd) Use this item to specify the delay from the activation of a bank to the time that a read or write command is accepted. The Choices: 2T, 3T, 4T, 5T (default). DRAM Burst Length The Choices: 4 (default), 8. DRAM Queue Depth This item permits to place the depths of the memory. the better is this function. The Choices: 4 level (default), 2 level, 3 level. The deeper the depth is, DRAM Command Rate This item controls clock cycle that must occur between the last valid write operation and the next command. The Choices: 1T Command, 2T Command (default). Write Recovery Time This item allows you to select the recovery time. The Choices: 2T, 3T (default). 13