Biostar NF61S-M2 TE Setup Manual - Page 40

Bottom of UMA DRAM [31:24] - processor

Get Biostar NF61S-M2 TE PDF manuals and user guides View all Biostar NF61S-M2 TE manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

NF61S-M2 TE BIOS Setup CKE base power down mode The Choices: Disabled (default), Enabled. CKE base powerdown The Choices: Per Channel (default), Per CS. Memclock tri-stating The Choices: Disabled (default), Enabled. Memory Hole Remapping The Choices: Enabled (default), Disabled. Auto Optimize Bottom IO The Choices: Enabled (default), Disabled. Bottom of [31:24] IO space The Choices: Min=0000 Max=00FF; Key in a HEX number. Bottom of UMA DRAM [31:24] The Choices: Min=0000 Max=00FC; Key in a HEX number. Special Notice: If the system's frequency that you are selected is not functioning, there are two methods of booting-up the system. Method 1: Clear the COMS data by setting the JCOMS1 ((2-3) closed)) as "ON" status. All the CMOS data will be loaded as defaults setting. Method 2: Press the key and Power button simultaneously, after that keep-on pressing the key until the power-on screen showed. This action will boot-up the system according to FSB of the processor It's strongly recommended to set CPU Vcore and clock in default setting. If the CPU Vcore and clock are not in default setting, it may cause CPU or M/B damage. 40

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
NF61S-M2 TE BIOS Setup
40
CKE base power down mode
The Choices: Disabled
(default), Enabled.
CKE base powerdown
The Choices: Per Channel
(default), Per CS.
Memclock tri-stating
The Choices: Disabled
(default), Enabled.
Memory Hole Remapping
The Choices: Enabled
(default), Disabled.
Auto Optimize Bottom IO
The Choices: Enabled
(default), Disabled.
Bottom of [31:24] IO space
The Choices:
Min=0000
Max=00FF; Key in a HEX number.
Bottom of UMA DRAM [31:24]
The Choices:
Min=0000
Max=00FC; Key in a HEX number.
Special Notice:
If the system’s frequency that you are selected is not functioning, there are two methods
of booting-up the system.
Method 1:
Clear the COMS data by setting the JCOMS1 ((2-3) closed)) as “ON” status. All the
CMOS data will be loaded as defaults setting.
Method 2:
Press the <Insert> key and Power button simultaneously, after that keep-on pressing the
<Insert> key until the power-on screen showed.
This action will boot-up the system according to FSB of the processor
It’s strongly recommended to set CPU Vcore and clock in default setting. If the CPU
Vcore and clock are not in default setting, it may cause CPU or M/B damage.