Biostar P4M80-M7A V7.X P4M80-M7A user's manual - Page 14
Memory Module Installation
 |
View all Biostar P4M80-M7A V7.X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
P4M800-M7 & P4M800-M7 A 2.3 1. MEMORY MODULE INSTALLATION Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot. 2. Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated. Note: To assure the system safety, if you need to change DDR modules, firstly, please unplug the 20-pin power cable with the power connector, and then you can change the modules. Afterwards, plug in the cable the power connector again, and finally you can boot up the system. 12
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17 -
18 -
19 -
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
 |
 |
P4M800-M7 & P4M800-M7 A
12
2.3
M
EMORY
M
ODULE
I
NSTALLATION
1.
Unlock a DIMM slot by pressing the retaining clips outward. Align a
DIMM on the slot such that the notch on the DIMM matches the
break on the Slot.
2.
Insert the DIMM vertically and firmly into the slot until the retaining
chip snap back in place and the DIMM is properly seated.
Note:
To assure the system safety, if you need to change DDR modules, firstly,
please unplug the 20-pin power cable with the power connector, and
then you can change the modules. Afterwards, plug in the cable the
power connector again, and finally you can boot up the system.