Bissell Big Green Complete Deep Cleaner/Vacuum 7700 User Guide - English - Page 10

Operations Getting ready to wet clean NOTE: Remove tool caddy if in place. 1. Attach the desired wet cleaning tool to end of wand or grip. 2. Open the Quick Release™ Hose Door and select "WET CLEAN" with the mode selector. 3. Place the clean solution tank on a flat surface. 4. Fill the solution tank by first unscrewing the measuring cap. Always use genuine BISSELL 2X formulas to maximize cleaning and for the safety of your machine. Fill tank to fill line with hot tap water. Add two full measuring caps of formula. Screw measuring cap tightly back onto the solution tank. 5. Place the solution tank back in the machine. 6. Make sure the float is in place. To install, slide float into the channel located on "Fill Line" side of the collection tank. There is only one way to properly install the float. 7. Plug into a proper outlet and press the ON/OFF, wet clean and heater (if desired) buttons down into the ON position. Note: Allow one minute for the built-in heater to warm up before cleaning. The Big Green Complete will be fully warmed and will provide optimal performance after one minute in the heater ON position. Tip: Move furniture to another area if cleaning an entire room. 2 4 5 10 w w w. b i s s e l l . c o m 800.237.7691