Bissell Carpet Cleaners User Guide 4 - Page 11

Using the 2-in-1 Pet Upholstery Tool Make sure your Clean Water Tank has water & formula to use the tool in wet mode. 1 2 Dry Mode (switch up) Dry Suction Channel Follow hose plug-in instructions from steps 1 & 2 on page 10. Attach the tool and select dry mode to first pick up dry debris and pet hair. The suction will be at the lower part of the tool, near the dry cup. DRY MODE NOTE: Use a "raking" motion to clean. Start with the tool farthest away and rake in small increments as you bring the tool toward you. The rubber nubs will help attract hair to the suction channel. 3 Empty the cup when it fills with hair and 4 debris. 6 Take off the cup to empty hair and debris. 5 Turn OFF the machine. Hold the cup and twist counter-clockwise line up the arrow with the unlock symbol and remove. Remove hair that may wrap around the filter. To reattach the cup, line up the cup to the tool indents, and rotate clockwise. The arrow will line up with the locked icon when secured. 7 8 Wet Suction Channel Wet Mode (switch down) To deep clean, move the switch to wet mode. Press the trigger to spray your water and formula; use the top of the Nozzle to extract stains and odors. To remove any hair or trapped debris from the Nozzle, first turn OFF the machine. Pull the Nozzle tab away from the tool to remove and rinse under running water. 9 Replace on the tool by lining up the Nozzle edge and snap into place. Before storing, make sure all hair is removed from the dry cup and Nozzle has been rinsed under running water. WET MODE NOTE: Start from the area farthest away. Hold the trigger down, and pull the tool toward you. Keep the tool in contact with the surface as you pull. You will see extraction through the Nozzle. www.BISSELL.com 11