Bissell Carpet Cleaners User Guide 4 - Page 16
Replacing the Belts & Brush Rolls
View all Bissell Carpet Cleaners manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Replacing the Belts & Brush Rolls WARNING To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. What you will need: 1 Phillips-head screwdriver & 1 flathead screwdriver 1 While the machine is upright, unplug the machine and remove both tanks. Remove the Nozzle and Brush Roll cover (see steps in Brush Roll & Nozzle Care). Press the Recline Pedal and lay the machine on its back. 2 Use a flathead 3 Turn the machine on its side and use a Phillips-head screwdriver to remove screwdriver and the screw just underneath the wheel. press it into the slot Slide the wheel down to remove. at the back and then front of the Belt Access Door. Lift to remove the door. 4 5 Lay the machine If the gear belt back down on is broken, gently its back. Use a remove it. If you Phillips-head are replacing your screwdriver to Brush Rolls, gently remove the screw remove the belt. on the Brush Roll end cap. 6 There are washers Align Brush Rolls with belt at the ends of the at other end. To ensure Brush Rolls, be alignment, hold the end careful that these of one Brush Roll and do not fall off or twist. The other Brush get lost. Roll rotates with it. Check that washers are in place. Reassemble the belt and end cap, securing with screws you removed. NOTE: To replace Brush Rolls, remove them from the metal posts and replace. Make sure the metal post goes completely through the end of the Brush Roll. The bristles should be aligned in a 'V' pattern as pictured. 16 www.BISSELL.com