Bissell PowerForce® Bagged Vacuum 71Y7V User Guide - English - Page 10

Maintenance and care Check rotating floor brush & drive belt (cont) 5. Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends. 6. Clean strings, hair and other debris from motor pulley and drive belt areas. 7. Check drive belt carefully for wear, cuts or stressed areas. Replace if worn. 8. Check air passageway for obstructions. Remove debris from this area. Replace drive belt Use only BISSELL Style 7 Replacement Belts (#32074) in your BISSELL PowerForce. 1. Unplug cleaner from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of Check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating floor brush down into slots on sides as shown. 5. Turn rotating floor brush by hand several times in direction of motor pulley. If properly installed, drive belt will center itself. 6. Reposition brush cover and four screws. Tighten screws securely. Make sure end of brush cover is snapped into place. Motor Pulley Press here Air Passageway Brush Cover 10 w w w. b i s s e l l . c o m 800.237.7691