Black & Decker BEHT200 Instruction Manual - Page 7

Attaching the Bail Handle (FIG. D, E) 1. Cut the plastic zip tie. 2. Remove the 4 screws that are partially run into the trimmer housing (Fig. D). Fig. D 3. Slide the bail handle onto the front of the trimmer housing behind the guard. 4. Insert the four screws into the openings on the side of the bail handle and tighten securely as shown in Fig. E. Fig. E Attaching Extension Cord to Trimmer (FIG. F) WARNING: Ensure the trigger switch is not engaged to reduce the risk of starting the appliance accidentally. A cord retainer is incorporated into the rear of the handle on the power head. 1. Near the end of the extension cord, fold the extension cord to create a loop. 2. Feed the loop into the cord retainer housing 10 as shown in Fig. F. 3. Hook the loop onto the cord retainer 7 so it rests in the cord retainer. 4. Plug the extension cord into the power head. Fig. F 7 English SAVE THESE INSTRUCTIONS FOR FUTURE USE OPERATION WARNING: To reduce the risk of serious personal injury, turn unit off and disconnect it from power source before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. Proper Hand Position (Fig. G) WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown. WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden reaction. Always hold the trimmer, as shown in the illustrations in this manual, with one hand on the switch handle and one hand on the bail handle (Fig. G). Never hold the unit by the blade guard. Switch To turn the tool "ON", slide the lock off button 4 , shown in Fig. G, backward and squeeze the trigger switch 5 . Once the unit is running, you may release the lock off button. In order to keep the unit running you must continue to squeeze the trigger. To turn the tool "OFF", release the trigger. WARNING: Never attempt to lock a switch in the ON position. Fig. G 4 5 11 Trimming Instructions 1. EXTENSION CORD - (Fig. H) - Always keep extension cord behind trimmer and away from the trimming operation. Never drape it over a hedge being trimmed. If you cut or damage the cord, unplug it at the electrical outlet immediately, before inspecting or repairing cord. 2. WORKING POSITION - Maintain proper footing and balance and do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the tool firmly in both hands and turn the tool ON. 5