Black & Decker FHV1200 Type 1 Manual - FHV1200 - Page 6

Optimizing the suction force In order to keep the suction force optimized, the filters must be cleared regularly during use. • Turn the filter cleaning wheel (5) two turns clockwise to remove any dust from the filters. • The fine particulate filter must be cleaned regularly, see "Cleaning the fine particulate filter" section. Cleaning and maintenance Emptying the dust container The dust container must be emptied regularly, preferably after every use. • Pull the door latch (9) and open the transparent door (7) 180 degrees. • Tilt unit to empty dirt. • Tap the back end of unit if debris does not fall out easily or remove filters for better access. WARNING: Do not, under any circumstances rinse out the dust container or immerse the appliance in water. A damp cloth and soapy water should be used to clean the exterior of the appliance. Always make sure that the appliance is completely dry before re-use or storing. E Cleaning filters (figures E,F) 17 Both the plastic pre-filter (17) and the pleated filter (18) are re-usable and should be cleaned regularly. • Pull the door latch (9) and open the transparent door (7) 180 degrees. • Remove the pre-filter (17) from the appliance as shown in figure E. • Remove the pleated filter (18) by pulling firmly (figure F). • Tap the filters vigorously to remove loose dust. • If necessary, wash the filters in warm, soapy water. • Make sure that the filters are dry. • Refit the pleated filter (18) into the dust container. • Refit the pre-filter (17) into the dust container. • Close the transparent door (7) and make sure that it clicks into place. F 18 6