Black & Decker HH2455 Type 1 Manual - HH2455 - Page 4
Trimming Instructions - black n decker
View all Black & Decker HH2455 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Figure F depicts the rear handle in 90° left (f1), 0° (f2) and 90° right (f3) positions. F f1 f2 f3 TRIMMING INSTRUCTIONS 1. EXTENSION CORD - (Figure G) Always keep G extension cord behind trimmer and away from the trimming operation. Never drape it over a hedge being trimmed. If you cut or damage the cord, unplug it at the electrical outlet immediately, before inspecting or repairing cord. 2. WORKING POSITION - Maintain proper footing and balance and do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the tool firmly in both hands and turn the tool ON. Always hold the trimmer, as shown in figure G, with one hand on the switch handle and one hand on the bail handle. Never hold the tool by the blade guard. 3. TRIMMING NEW GROWTH - (Figure H) - A wide, H sweeping motion, feeding the blade teeth through the twigs is most effective. A slight downward tilt of the blade, in the direction of motion gives the best cutting. CAUTION: Do not use the trimmer for cutting stems greater than 3/4 in. (19mm). Use the trimmer only for cutting normal shrubbery found around houses and buildings. 6 I 4. LEVEL HEDGES (Figure I) - To obtain exceptionally level hedges, a piece of string can be stretched along the length of the hedge as a guide. J 5. SIDE-TRIMMING HEDGES (Figure J) - Begin at the bottom and sweep up. WARNING: TO GUARD AGAINST INJURY, OBSERVE THE FOLLOWING: • READ INSTRUCTION MANUAL BEFORE USING, SAVE INSTRUCTION MANUAL. • CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH AS WIRE OR FENCES BEFORE EACH USE. • KEEP HANDS AWAY FROM BLADES. • KEEP HANDS ON HANDLES. DONʼT OVERREACH. • CAUTION: - BLADE COASTS AFTER TURN OFF. • DO NOT USE UNDER WET CONDITIONS. • DO NOT USE WITH DAMAGED EXTENSION CORD. • DO NOT UNPLUG OR STORE WITH SWITCH LOCKED ON. DANGER: KEEP HANDS AWAY FROM BLADES. CAUTION: BLADE COASTS AFTER TURN OFF. TROUBLESHOOTING Problem Possible Cause Possible Solution • Unit will not start. • Cord not plugged in. • Plug tool into a working outlet. • Circuit fuse is blown. • Replace circuit fuse. (If the product repeatedly causes the circuit fuse to blow, discontinue use immediately and have it serviced at a Black & Decker service center or authorized servicer.) • Circuit breaker is tripped. • Reset circuit breaker. (If the product repeatedly causes the circuit breaker to trip, discontinue use immediately and have it serviced at a Black & Decker service center or authorized servicer.) • Cord or switch is damaged. • Have cord or switch replaced at Black & Decker Service Center or Authorized Servicer For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986. 7