Black & Decker LST400 Type 1 Manual - LST400 - Page 11

The RBRC™ Seal The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the LI-ION battery (or battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. RBRC™ in cooperation with Black & Decker and other battery users, has established programs in the United States to facilitate the collection of spent LI-ION batteries. Help protect our environment and conserve natural resources by returning the spent LI-ION battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery. RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation. Maintenance WARNING: To avoid serious injury, remove the battery from the trimmer before performing any maintenance. CAUTION: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. 1. Keep the air intake slots clean to avoid overheating. 2. Your trimmer line can dry out over time. To keep your line in top condition, store spare pre- wound spools or bulk line in a plastic, sealable bag with a tablespoon of water. 3. Plastic parts may be cleaned by using a mild soap and a damp rag. 4. The line cutter on the edge of the guard can dull over time. It is recommended you periodically touch-up the sharpness of the blade with a file. Troubleshooting TRIMMER runs slowly • Remove Battery from tool. • Check that the spool housing can rotate freely. Carefully clean it if necessary. • Check that the cutting line does not protrude more than approximately 5-3/8 inches (136mm) from the spool. If it does, cut it off so that it just reaches the line trimming blade. Automatic line feed does not work • Remove Battery from tool. • Remove the spool cap. • Pull the cutting line until it protrudes approximately 5-3/8 inches (136mm) from the spool. If insufficient cutting line is left on the spool, install a new spool of cutting line. • Ensure that the line is not crisscrossed on the spool as detailed in figure R. If it is, unwind the cutting line, then wind it back on the spool neatly so that the lines do not cross. • Ensure the beginning of the cutting line is pulled tight against the spool as shown in figure Q. • Align the tabs on the spool cap with the cut outs in the housing. • Push the spool cap onto the housing until it snaps securely into place. • If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade. If the automatic line feed still does not work or the spool is jammed, try the following suggestions: • Carefully clean the spool and housing. • Remove the spool and check if the lever in the spool housing can move freely. • Remove the spool and unwind the cutting line, then wind it on neatly again. Replace the spool into the housing. Service Information All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, call: 1-800-544-6986 or visit www.blackanddecker.com 11