Bosch 1587AVSP-1 Operating Instructions - Page 11

BM 2610993477 2-04 2/9/04 9:24 AM Page 11 load or very abrasive material cutting) should be replaced at once to avoid overheating or motor failure. Cleaning ! WARNING To avoid accidents always disconnect the tool from the power supply before cleaning or performing any maintenance. The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with compressed air. Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through openings. ! CAUTION Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia. Accessories ! WARNING If an extension cord is necessary, a cord with adequate size conductors that is capable of carrying the current necessary for your tool must be used. This will prevent excessive voltage drop, loss of power or overheating. Grounded tools must use 3- wire extension cords that have 3-prong plugs and receptacles. NOTE: The smaller the gauge number, the heavier the cord. RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT ALTERNATING CURRENT TOOLS Tool's Ampere Rating 3-6 6-8 8-10 10-12 12-16 Cord Size in A.W.G. Wire Sizes in mm2 Cord Length in Feet Cord Length in Meters 25 50 100 150 15 30 60 120 18 16 16 14 18 16 14 12 18 16 14 12 16 16 14 12 14 12 - - 0.75 0.75 1.5 2.5 0.75 1.0 2.5 4.0 0.75 1.0 2.5 4.0 1.0 2.5 4.0 - --- - ** Vacuum hose ** Hose/vacuum adaptor ** Anti-splinter insert (5pcs.) ** Cutting guide * Allen wrench 5mm * Steel footplate insert (1587AVS & 1587DVS) * Plastic footplate insert (1587AVSK & 1587DVS) * Carrying case (1587AVSK) (*= standard equipment) (**= optional accessories) -11-