Bosch 1587AVSP-1 Operating Instructions - Page 9

BM 2610993477 2-04 2/9/04 9:24 AM Page 9 FLUSH CUTTING To allow the saw to make a perpendicular cut close to a vertical surface, the footplate may be repositioned as follows. Remove screw (A), move footplate to the front mounting slot, and be sure the detent notch is aligned with the detent slot in the footplate. Re-insert screw (A) into the threaded hole closest to the detent notch, and securely tighten. Note that when the footplate is retracted in this manner, only 90˚cuts are possible, and dust cover or optional cutting guide may not be used. DETENT NOTCH 0 15 30 45 SCREW (A) ANGLE SCALE CHIP BLOWER The jigsaw is equipped with a three-position chip blower to help keep the cutting line clear of chips. By adjusting the chip blower lever, the force of the discharged air may be altered as follows; Strongest blowing action for working in woods and similar materials. Medium blowing action. No blowing action DUST EXTRACTION (1587AVS & 1587DVS) Model 1587DVS is equipped with a dust port for chip extraction. To use this feature, attach vacuum hose (optional accessory) to the dust port connector, than attach the dust port connectorto the dust port. Connect the other end of hose to a shop vacuum cleaner with adapter (optional accessories). For maximum efficiency, dust covermust be in place. Model 1587AVS can be converted to dustless by adding the "Dust Collection Adapter Kit" which is available from Bosch Service Centers or Distributors. * Included in "Dust Collection Adapter Kit" * DUST PORT * DUST PORT CONNECTOR * COVER SCREW (A) 0 15 30 45 -9- FOOTPLATE PLATE * COVER FOOTPLATE INSERT SCREW (B)