Bosch 3814 Operating Instructions - Page 7

ADJUSTABLE DEPTH STOP BOLT Your tool is equipped with a depth stop bolt. As the wheel wears, or when replacing a wheel it will be necessary to make this adjustment. TO RAISE WHEEL, Loosen nut on depth stop bolt and rotate bolt counter-clockwise with the wrench provided. TO LOWER WHEEL, rotate depth stop bolt clockwise. Attention: To maintain adjustment, securely tighten nut on the depth stop bolt with the wrench provided. CARRYING THE TOOL 1. Lower arm as far as it will go, and attach the hold down chain to the hook provided and release tension on arm. 2. Raise the depth stop adjustment bolt until the bolt touches the arm as shown in (Fig. 4) to prevent any movement or bouncing of the arm. ! CAUTION Be certain that the hold down chain is tightly secured to the base and arm for transporting. If the abrasive cut off machine is carried in the open position the depth stop may be damaged. FIG. 4 HANDLE DEPTH STOP ADJUSTMENT BOLT LOCK NUT HOOK HOLD DOWN CHAIN Adjusting the Vise CHANGING CUTTING ANGLE 1. Loosen the vise stop adjustment bolts with the wrench provided, (Fig. 5), DO NOT REMOVE. QUICK RELEASE LEVER To release work, turn crank to loosen, lift quick release lever up (Fig. 5), and pull screw shaft away from work. 2. Align desired angle on vise stop scale with index line in base, and securely tighten bolts with the wrench provided. To lock work, push screw shaft toward work, lower quick release lever and turn crank clockwise to tighten. OPENING ADJUSTMENT 1. Loosen vise stop adjustment bolts with the wrench provided (Fig. 5), DO NOT REMOVE. 2. Slide vise stop forward or backward to desired location, and securely tighten bolts with the wrench provided. MAXIMUM CUTTING DEPTH To obtain maximum cutting depth, position vise stop so material being cut is approximately centered under wheel, when wheel is lowered all the way down. FIG. 5 QUICK RELEASE LEVER VISE STOP CRANK SCREW SHAFT WRENCH BASE VISE STOP ADJUSTMENT BOLTS -7- SCALE INDEX LINE