Bosch HBL87M52UC Installation Instructions - Page 11
Connecting the Speed Oven or Steam, Convection Oven Electrical Conduit to the, Lower Oven
View all Bosch HBL87M52UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. Install the decorative trim. Position the decorative trim piece so the flanges with the holes in them face to the rear of the oven. Align the inner flanges with the inside of the universal brackets. Fasten with one (1) screw each into the end hole of the universal bracket. Tighten screws securely but do not overtighten. Connecting the Speed Oven or Steam Convection Oven Electrical Conduit to the Lower Oven Note: When installing the combination unit, the speed oven or steam convection oven, the power cable must be properly attached to the oven-mounted junction box. This must be done prior to supplying electrical power to the oven unit. 9 WARNING Check to be sure that no electrical power has yet been supplied to the oven. 1. Remove the oven-mounted junction box cover located on the top rear of the oven. (See image below). 6. Place the steam convection oven unit on top of the universal connector brackets and fasten in place using two (2) screws per side. Tighten the screws securely, but do not overtighten. Note: The existing screws in the steam convection oven base help with alignment. When lowering the steam convection oven into place on the universal connector brackets, allow these screw heads to slide into the slots as shown in the illustration below. The screw nearest the front of the steam convection oven should slide into the base of the slope at the front of the bracket. 2. Remove the cap from the conduit access hole in the side of the oven-mounted junction box. 7. Continue to "Connecting the Speed Oven or Steam Convection Oven Electrical Conduit to the Lower Oven". 11