Bosch HMC87152UC Installation Instructions - Page 9

Three-wire Connection Grounded Neutral SRZHUVXSSO\ MXQFWLRQER[ UHGZLUHV ZKLWHEDUHRU JUHHQZLUH ZKLWHZLUH JUHHQZLUH EODFNZLUHV 8/OLVWHG FRQQHFWRU FDEOHIURP RYHQ ▯ Connect red wire from oven to red wire in junction box. ▯ Connect black wire from oven to black wire in junction box. ▯ Connect both green ground wire and white wire from oven to white, green or bare neutral wire in junction box. The conduit cable, where connected at the oven, swivels. Rotate conduit cable upward (or downward) and direct through hole prepared in cabinet to attach to junction box. To maintain serviceability, the flex conduit must not be shortened and should be routed to permit temporary removal of the oven. Install Appliance Note: The appliance is heavy. It is advisable to install it with a second person. NOTICE: Before installing the appliance, be sure to verify the cabinet dimensions and electrical connections. Mount to Cabinet 1. Fully insert the appliance and center it. Do not kink the electrical cable. 2. Screw the appliance into place. Testing Operation 1. Turn on power at the breaker. 2. For Model HMC80252UC and HMCP0252UC: Check power at junction box using a volt meter. For 240 V installation, the reading between the red and black wires (line to line) should be 220 to 240 volts. For 208 V installation, the reading between the red and black wires (line to line) should be 190 to 208 volts. 3. For all models: Test the oven mode. Select the CONVECTION mode. See the Use and Care Manual for detailed operation instructions. 4. Verify that the oven light comes on and the oven begins to preheat. 5. Test the microwave: Place a cup of water into the oven cavity. Follow the instructions in the Use and Care Manual on how to heat a beverage. 6. Verify that the oven light comes on and the water is heated. 7. If any of the tests do not result as explained above, contact Service for assistance. Otherwise, the installation is complete at this time. 9