Bosch HMV8052U Installation Instructions - Page 4
Important Safety Instructions - install manual
View all Bosch HMV8052U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
9 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS S N I Y T E F A S T N A T R OD PA ME RI DNA INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS COMPLETE. IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE LOCAL ELECTRICAL INSPECTOR'S USE. WARNING If the information in this manual is not followed exactly, fire or shock may result causing property damage or personal injury. WARNING Do not repair, replace or remove any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by a qualified technician. Appliance Handling Safety Unit is heavy and requires at least two people or proper equipment to move. Do not lift appliance by door handle. Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance. Safety Codes and Standards This appliance complies with the latest version of one or more of the following standards: ▯ CAN/CSA C22.2 No. 61 - Household Cooking Ranges ▯ UL 858 - Household Electric Ranges ▯ CAN/CSA C22.2 No. 150 - Microwave Ovens ▯ UL 923 - Microwave Cooking Appliances ▯ UL 507 - Electric Fans ▯ CAN/CSA C22.2 No. 113 - Fans and Ventilators ▯ CSA C22.2 No. 64 - Household Cooking and Liquid- Heating Appliances ▯ UL 1026 - Electric Household Cooking and Food Serving Appliances It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations. State of California Proposition 65 Warnings WARNING This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. EVAS ESEHT Electric Safety SNO I TCURTSN I WARNING Before you plug in an electrical cord or turn on power supply, make sure all controls are in the OFF position. For appliances equipped with a cord and plug, do not cut or remove the ground prong. It must be plugged into a matching grounding type receptacle to avoid electrical shock. If there is any doubt as to whether the wall receptacle is properly grounded, the customer should have it checked by a qualified electrician. If required by the National Electrical Code (or Canadian Electrical Code), this appliance must be installed on a separate branch circuit. Installer - show the owner the location of the circuit breaker or fuse. Mark it for easy reference. Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally. Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical connections and grounding must comply with all applicable codes. Microwave Safety PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY ▯ Do not operate or allow the oven to be operated with the door open. ▯ Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary: 1. Interlock operation 2. Proper door closing 3. Seal and sealing surfaces (arcing, wear, and other damage) 4. Damage to or loosening of hinges and latches 5. Evidence of dropping or abuse ▯ Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity, and connection. ▯ Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before the oven is released to the owner. ▯ A microwave leakage check to verify compliance with the Federal Performance Standard should be performed on each oven prior to release to the owner. 4