Bosch NET5054UC Instructions for Use - Page 18

āService Troubleshooting The cooktop is not working E is flashing on the heating element display E will be flashing in all of the heating element displays, and an acoustic signal will be audible The cooktop has turned itself off Repairs Display E and numbers Display F and numbers If you encounter a problem, it frequently will merely be something minor. Before you call customer service, consider the following suggestions and instructions: Check the condition of the fuses/circuit breakers at your location. Check to see if you are experiencing a power failure. The touch control zone is very dirty, food has boiled over, or an object is lying on top of the control settings zone. Thoroughly clean the touch control zone, or remove the object lying on the zone if that may be causing the problem. Touch the touch control zone that seems to be involved in the problem. The flashing will stop. The main switch was operated continuously for longer than five seconds. Thoroughly wipe off the touch control zone and remove any objects that might be sticking to the zone. Enter your settings again. The main switch was accidentally touched. Turn the unit on again. Enter your settings again. Repairs may only be performed by trained customer service technicians. ř WARNING:ĄIf your unit is repaired in an unprofessional manner, you may be exposed to substantial risks. If an E and numbers appear in the display areas, an electronic fault has occurred. Use the building circuit breaker or the circuit breakers in your circuit breaker box to turn the unit off and then on again. If the display appears again, call customer service. If F and numbers appears in the display, your unit has detected a fault. The following table lists actions you can take to correct the problem. 18