Bosch NGM8057UC Installation Instructions 1 - Page 10
Connect Electrical Supply, Burner Cap and Burner Base Placement, Install Burner Grates
View all Bosch NGM8057UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
4. Retest for leaks by turning on the supply line gas shutoff valve. When leak check is complete (no bubbles appear), test is complete. 5. Wipe off all soap solution or detection fluid residue. Checking Burner Cap Placement Check to make sure that there is no gap between the burner parts. You may gently try to move the burner parts from side to side to check if they are properly placed. Important Notes for Gas Connection: ▯ The appliance and its individual gas shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5kPa). ▯ The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa). Connect Electrical Supply Before connecting the 40" (1 m) supply cord to a wall receptacle, make certain that gas shut-off valve and all burner controls are in OFF position. Burner Cap and Burner Base Placement The burner parts must be properly placed for the cooktop to function properly. If the burner parts are not properly placed, one or more of the following may occur: ▯ Burner flames are too high. ▯ Flames shoot out of burners. ▯ Burners do not ignite. ▯ Burner flames light unevenly. ▯ Burner emits gas odor. Install Burner Grates Properly position and install each burner grate as shown in the illustration below. 9 WARNING To prevent flare-ups, properly support pots and avoid spills, all grates must be properly positioned on the cooktop whenever the cooktop is in use. Each of the four feet must be placed into the corresponding dimples in the cooktop. Do not use a grate if the rubber feet are missing or damaged. Placing Burner Parts After electrical connection is complete, assemble the burner parts correctly and evenly. When assembling the burner parts, make sure that the burner head is placed on the base in such a way that the prongs of the burner cap fit snugly into the groove of the burner base. Parts 1 Igniter 2 Thermocouple 3 Burner base 4 Burner cap 10