Bosch NGM8057UC Installation Instructions 1 - Page 8
Installation Procedure
View all Bosch NGM8057UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation Procedure InstalionPrcedu Prepare Installation SpacePrepaInstlaionSpace Create the cut-out in the countertop according to the installation drawings. The angle of the cut surface to the countertop must be 90°. After creating the cut-out, remove shavings. Seal cut surfaces in a heat-resistant manner. Some solid surface countertops require special installations. For example, heat reflective tape and rounded corners may be necessary. Contact the countertop manufacturer for instructions specific to your countertop. 9 WARNING To avoid electrical shock hazard, before installing the cooktop, switch power off at the service panel to prevent the power from being switched on accidentally. Cut out the countertop per the dimensions shown in the section "Countertop Requirements". If there is no oven beneath the cooktop, install a noncombustible floor with a 3/8" (10 mm) space between the floor and the bottom of the cooktop. The distance from the intermediate floor to the power supply connection for the appliance must be at least 3/8" (10 mm). Install the Cooktop 9 WARNING Before you plug in an electrical cord or turn on power supply, make sure all controls are in the OFF position. 9 CAUTION Sharp edges. Use protective gloves when installing the cooktop. IMPORTANT: A foam tape seal is factory installed on the underside of the cooktop to prevent leaks. Do not remove the seal under any circumstances. 1. Screw each one of the clips into the position shown in the following image, so that they are free to rotate. 2. Turn the mounting brackets and tighten them fully. The orientation of the mounting brackets depends on how thick the countertop surface is. For countertops between 2" (50 mm) and 2¾" (70 mm) thick, insert a wooden block between the end of the adjusting screw and the bottom of the countertop. Note: Do not overtighten adjusting screw. [ 8