Bosch NITP068UC Installation Instructions - Page 5
Prepare Installation Space
View all Bosch NITP068UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Prepare Installation Space Create the cut-out in the countertop according to the installation diagram. The angle of the cut surface to the countertop must be 90°. The lateral cut-out edges must be flat in order to ensure that the retaining springs are positioned properly on the appliance. With multi-layered countertops, secure strips laterally in the cut-out if necessary. After creating cut-out, remove shavings. Seal cut surfaces in a heat- and water-resistant manner. Observe minimum distance between device underside and cabinet surfaces of 3/8" (10 mm). The worktop into which the cooktop is installed must be heat-resistant up to 140° F (90 °C). The worktop must be reinforced if it is less than 4/5 inch (20 mm) thick. If the thickness of the worktop into which the cooktop is installed does not comply with the specifications, reinforce the worktop using a fire- and water-resistant material until it reaches the minimum thickness. Otherwise, sufficient stability cannot be guaranteed. ▯ The worktop into which the cooktop is installed should withstand loads of approx. 133 lbs (60 kg). ▯ Only check the evenness of the cooktop after it has been installed. Cutout dimensions for 30" cooktops Models: NIT5068UC, NIT8068SUC, NIT8068UC, NITP068SUC, NITP068UC PLQPP PLQ PP PLQ PP ¡ PP [ PLQPP PLQPP PP PP 5