Bosch SHE55M15UC Instructions for Use - Page 16

Operating the, Dishwasher

Get Bosch SHE55M15UC - 24inchEvolution 500 Series Dishwasher PDF manuals and user guides
UPC - 825225868989
View all Bosch SHE55M15UC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

8 Operating the Dishwasher For Top Controls (Top controls are dishwashers with a hidden fascia panel. Please refer to the introduction page of this manual for examples). To start the dishwasher: • Open the door. • Press the ON/OFF button. • Select a cycle and desired options. • Close the door. To Interrupt a cycle: • Open the dishwasher door just far enough to expose the control panel. • Press the On/Off button to turn the unit off. • Wait at least 10 seconds before opening the dishwasher door. • To resume the cycle, press the On/Off button and close the dishwasher door. For FRONT Controls (Front controls are dishwashers with an exposed fascia panel. Please refer to the introduction page of this manual for examples). To start the dishwasher: • Press the ON/OFF button. • Select a cycle and desired options. To Interrupt a cycle: • Press the On/Off button to turn the unit off. • Wait at least 10 seconds before opening the dishwasher door. • To resume the cycle, press the On/Off button and close the dishwasher door. NOTE: Should you need to interrupt a cycle (to add or remove an item, to add detergent, etc.), it is best to do so within the first 30 minutes of the cycle. WARNING You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped. Canceling or changing a cycle To cancel or change a cycle, open the dishwasher door far enough to expose the control buttons then press and hold the "Cancel/Reset" buttons for 3 seconds. Cancel / Reset Close the door and wait until the dishwasher completes the cycle (approx. 1 min). Open the door and press the ON/OFF button. You may now begin a new cycle. Dishware Drying At the end of the cycle the dishwasher will stop and a period of condensation drying will follow. After drying, the cycle is complete and depending on your model: • the "Clean" light will illuminate OR • the cycle completion signal will sound OR • the countdown display will show "0" OR • The InfoLight™ will turn off. • When the cycles are complete, the "Sanitized" indicator (select models) on your dishwasher control panel will illuminate. However, if your household water supply is too hot, your dishwasher's heating time may be reduced, and the Sanitized indicator may not illuminate. 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
16
8
Operating the
Dishwasher
FOR TOP CONTROLS
±Top controls are dishwashers with a hidden fascia panel.
Please refer to the introduction page of this manual for
examples).
To start the dishwasher:
Open the door.
•
Press the ON/OFF button.
•
Select a cycle and desired options.
•
Close the door.
•
To Interrupt a cycle:
Open the dishwasher door just far enough to expose
•
the control panel.
Press the
•
ON/OFF button to turn the unit off.
Wait at least 10 seconds before opening the
•
dishwasher door.
To resume the cycle, press the
•
ON/OFF button and
close the dishwasher door.
FOR FRONT CONTROLS
±Front controls are dishwashers with an exposed fascia
panel. Please refer to the introduction page of this manu-
al for examples).
To start the dishwasher:
Press the ON/OFF button.
•
Select a cycle and desired options.
•
To Interrupt a cycle:
Press the
•
ON/OFF button to turn the unit off.
Wait
at
least
10
seconds
before
opening
the
•
dishwasher door.
To resume the cycle, press the
•
ON/OFF button and
close the dishwasher door.
NOTE: Should you need to interrupt a cycle (to add or
remove an item, to add detergent, etc.), it is best to do so
within the first 30 minutes of the cycle.
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not
fully open the door until water noises have stopped.
WARNING
Canceling or changing a cycle
To cancel or change a cycle, open the dishwasher door
far enough to expose the control buttons then press and
hold
the “Cancel/Reset” buttons for 3 seconds.
Close the door and wait until the dishwasher completes
the cycle (approx. 1 min). Open the door and press the
ON/OFF button. You may now begin a new cycle.
Cancel / Reset
Dishware Drying
At the end of the cycle the dishwasher will stop and a
period of condensation drying will follow. After drying,
the cycle is complete and depending on your model:
the “Clean” light will illuminate OR
•
the cycle completion signal will sound OR
•
the countdown display will show "0" OR
•
The InfoLight
•
™
will turn off.
When the cycles are complete, the “Sanitized”
•
indicator (select models) on your dishwasher control
panel will illuminate. However, if your household
water supply is too hot, your dishwasher’s heating
time may be reduced, and the Sanitized indicator
may not illuminate.