Bosch SHE5AL06UC Use and Care Guide - Page 11
Warning
UPC - 825225875154
View all Bosch SHE5AL06UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATING THE SHX3AM, SHX5AL, & SHX6AP WARNING You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped. To Start Unit: • Door must be open. Press the "ON/OFF" button to turn the unit on. • One of the Wash Cycle Indicator Lights will be flashing to show you are in the Wash Cycle selection mode. • Press the "" button to select the desired wash cycle. • Press the "START" button (Wash Cycle Indicator Light will stop flashing) • Close the door to start the cycle Note: Rinse Agent Indicator Light will be illuminated if the unit needs Rinse Agent. Note: If you close the door without pressing the start button the unit will beep. To Cancel the Cycle: • Open the door just far enough to expose the controls. Be careful of water Splash Out! • Press and hold the "START/RESET" button until the "Active" Indicator Light goes out. • Close the door and wait for about 1 minute for the dishwasher to drain. • Open the door and press the "ON/OFF" button. • You are now ready to start a new cycle. Setting Options (Rinse Agent Amount / Extra Dry Heat Activation / Cycle Completion Signal Tone Level) • Door must be open. Press the "ON/OFF" button to turn the unit on. • One of the Wash Cycle Indicator Lights will be flashing to show you are in the Wash Cycle selection mode. • To enter the Options Setup Mode, press and hold down the ">" button, then press and release the "START RESET" button, then release the ">" button. • The "Clean" Indicator Light and at least one addition Indicator Light will be flashing to show you are in the Options Setup Mode. • Press the ">" button to select the option you would like to adjust. o If the "CLEAN" and "RINSE AGENT" Indicator Lights are flashing you are ready to set the amount of Rinse Agent the unit will dispense. o If the "CLEAN" and "SANITIZED" Indicator Lights are flashing you are ready to turn your Extra Dry Heat option on/off. o If the "CLEAN" and "SANITIZED" and "RINSE AGENT" Indicator Lights are flashing you are ready to set the Cycle Completion Signal Tone Level. To Set the Amount of Rinse Agent Dispensed NOTE: If your glasses have spots you need more Rinse Agent. If your glasses have streaks you need less Rinse Agent. • With the "CLEAN" and "RINSE AGENT" Indicator Lights flashing. • Press the "