Bosch SHP53T55UC Instructions for Use - Page 13
Rinse Aid, Setting the amount of rinse aid - lowes
View all Bosch SHP53T55UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Table 1 - Recommended Detergent Amount Wash Cycle Hard Water/ Heavy Soil Medium Water/ Medium Soil Soft Water/ Little Soil Heavy 45ml (3tbsp) 45ml (3tbsp) 25-45ml (1.75-3tbsp) Auto 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp) Normal 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp) Speed60™ 25ml (1.75tbsp) 15-25ml (1-1.75tbsp) 15ml (1tbsp) Rinse None None None Rinse Aid Your dishwasher was designed to use rinse aid for best drying results. To achieve proper drying, always use a liquid rinse aid, even if your detergent contains a rinse aid or drying additive. Note: The dishwasher indicates low rinse aid by turning on the "Add Rinse Aid" indicator light. If this light is on, you need to refill the rinse aid dispenser by following the directions below. If the light is not on, your dishwasher still has enough Rinse Aid and there is no need to refill it. Adding Rinse Aid Add liquid rinse aid to the dispenser until it is full (see Figure 9). Wipe up any excess rinse aid that may puddle when the dispenser reservoir is full. Lid must be snapped fully closed in order to seal. The indicator light will go out a few moments after the dishwasher door is shut. See below for instructions on how to adjust the amount of rinse aid dispensed. Note: Setting the rinse aid to "r:00" may increase cycle times. Figure 9 Setting the amount of rinse aid The amount of rinse aid dispensed can be set from "r:00" to "r:06". 1 Press the [On/Off] button. 2 Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00". Release both buttons. 3 Press the "A" button until the display shows "r:05". 4 Press the "C" button to select the desired setting. "r:00" = dispenser is OFF "r:04" = medium/high setting "r:01" = lowest setting "r:05" = high setting "r:02" = low setting "r:03" = medium setting "r:06" = highest setting 5 Press [Start] to save the setting. 12