Bosch SHP53T55UC Instructions for Use - Page 17
Start the dishwasher, Cancel a cycle, Interrupt a cycle, Cycle Completion Signal, Delay Start - 02
View all Bosch SHP53T55UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
NOTE: For models with hidden controls, the door must be opened before changing settings and closed after changing settings. NOTICE: Use caution when opening door during a running cycle. Hot water may splash out. Open door slowly. Start the dishwasher 1 Press the [On/Off] button. 2 Select a cycle (Auto cycle is preselected) and desired options. 3 Press [Start] and the cycle will begin. Cancel a cycle 1 Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01". 2 Wait about 1 minute while the dishwasher drains and the display reads "0:00". 3 Press the [On/Off] button. You may now power the dishwasher back on and begin new cycle if desired. Interrupt a cycle 1 Press the [On/Off] button to turn the unit off. 2 To resume the cycle, press the [On/Off] button again. Cycle Completion Signal 1 Open the door and press the [On/Off] button. 2 Hold down the "A" button (see page 15) and press [Start] until the display indicates "d:00". Release both buttons. 3 Press the "A" button until the display shows "b:02". 4 Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST 5 Press [Start] to save setting and close the door. Delay Start You can delay the start of the cycle in one hour increments up to 24 hours. 1 Press the [On/Off] button and select desired cycle. 2 Press the [Delay] button until the displayed time corresponds with your requirements. h:01 = 1 hour delay h:24 = 24 hour delay 3 Press [Start] to activate delay start. Wash cycle will begin after set time. To cancel delay start: 1 Press the [Delay] button until "h:00" is indicated on the digital dis- play. 2 Press [Start] to save setting. 16