Bosch WTVC8530UC Operating Guide - Page 14

supplied parts illustration.

It is

illustrated separately from the hose

for clarity.

3. If space permits, attach the

internally threaded (female) end of

the "Y" connector

directly to the

cold water faucet (option A as

shown in the illustration above)

and continue to step 6

For optional

Installation

with Y

Connector

If the "Y" connector cannot be

attached directly, use the short

hose provided to connect the "Y"

connector to the cold water faucet

(option B as shown in the

illustration below),

and continue

with steps

4 through

5.

4. Attach the short hose to the cold

water faucet.

Tighten the

connection

by hand until the

coupling is seated on the faucet.

5. Use pliers to tighten the

connection

an additional

two

thirds turn.

D

Do not overtighten.

Damage to the

coupling could result.

6. Attach the "Y" adapter to the short

hose.

Tighten the coupling by

hand until it is firmly seated on the

hose.

%

Do not use pliers to tighten plastic

threaded fittings onto plastic or

metal threaded connections.

7. Attach the washer cold water

supply hose to the "Y" connector.

Hand tighten only.

8. Attach the dryer water supply hose

to the other coupling of the "Y"

connector.

Hand tighten only.

9. Tighten only metal-to

metal

couplings on the "Y" connector

and short hose an additional

two

thirds turn using pliers.

%

10.

%

11.

%

12.

13.

Do not overtighten.

Damage to

the coupling could result.

Attach the right-angle

connector

on the water supply hose to the

inlet valve located at the top left of

the dryer.

Check to see that the rubber

washer does not fall out, and is

properly seated in the right

angle

connector.

Hand tighten

the coupling until it

is seated on the connector.

Do

not use pliers, hand tighten only.

Do not overtighten.

Damage to

the coupling could result.

Turn on the water faucet.

Check for leaks around the "Y"

connector,

faucet and all hoses.

Electrical

Connection

GROUNDING

INSTRUCTIONS

The dryer must only be connected

to an individual branch circuit via a

socket which has been properly

installed and grounded.

The household electrical voltage must

correspond to the voltage specification

on

the dryer

(rating plate).

You will find the rating plate on the

inside of the front panel.

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

i

Connection specifications

as well as

the electrical requirements are

stipulated on the appliance nameplate.

Make sure that:

the power cord plug fits into the

socket.

the power cord is acceptable for

use in this application.

the grounding system is properly

installed.

The power cord may be replaced by a

qualified technician or a licensed

electrician only.

Replacement

power cords are available

from Customer Service (see page 32).

Volts

Hertz

Amperes

Watts

110 120

60

9

1080

14

Bosch WTVC8530UC Operating Guide - Page 14

Electrical, Connection

Page 14 highlights