Bose 033975 Owners Guide - Page 6

SETTING UP YOUR WAVE® MUSIC SYSTEM III Unpacking Please check the shipping carton for the following items: 3. Unwind and straighten the power cord to ensure the best FM and digital radio reception. The power cord is used as an antenna. ® Wave® music system III AC power cord(s)* 3.5 mm input cable DAB dipole antenna Remote control Antenna adapter (battery installed) Demonstration CD (Europe & UK only) *The appropriate power cord(s) for your region is supplied. Selecting a location • Place your Wave® music system III on a table or other flat surface. • To enjoy maximum audio performance, place your Wave® music system III across the room from where you will be listening. • For best audio performance, place your Wave® music system III within two feet of a wall, and avoid placing directly in a corner. Notes: • Do not place your Wave® music system III on a metal surface. It could interfere with AM reception. • Do not place your Wave® music system III on a heat- sensitive surface. Like all electrical equipment, it generates some heat. • Do not use your Wave® music system III in a damp location or any other place where moisture can get inside. Connecting to power 1. Insert the small end of the power cord into the connector labeled AC POWER on the rear panel of your Wave® music system III. 2. Plug the power cord into an electrical outlet. 1 2 AC POWER 3 Setting the clock After plugging in your Wave® music system III, set the clock using the remote. Your Wave® music system III is easily operated using the remote control. Just aim the remote at the front panel and press the necessary buttons. 1. Press and hold down either Time button for about 1 sec. Note: Press-and-hold operations require holding the button down for about one second. Initially, HOLD_TO_SET appears on the display and then quickly changes to - CLOCK SET - as the button is depressed. 2. Release the selected Time button. 3. Press Time - to adjust the displayed time backward or press Time + to adjust the displayed time forward until it matches the current time. You can also press and hold for rapid adjustment. 4. Wait five seconds for the system to exit the clock setup mode automatically. Notes: • To change the clock display from 12-hour (AM/PM) time to 24-hour time, see "Changing the time format" on page 20. • If the Wave® music system III loses power due to a power outage or uplugging the unit to move it, all system settings will be permanently retained. However, the clock time will only be temporarily stored in backup memory for up to 48 hours. 6 - English