Bose Acoustimass 10 Series III Owner's guide - Page 12
Checking the connections, Connecting the Acoustimass module to power
View all Bose Acoustimass 10 Series III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Setting Up Checking the connections Check all connections from the receiver to the powered Acoustimass® module and from the module to the cube speakers (Figure 5 and Figure 6). Make sure the cube speakers are connected to the proper terminals according to their position in your room. Check that the wires are connected to your surround receiver in phase (+ to + and - to -). Correct wiring problems before you plug your receiver in and turn it on. Connecting the Acoustimass module to power Note: Bose® recommends using a quality surge suppressor on all electronics equipment. Voltage variations and spikes can damage electronic components in any system. A quality suppressor can eliminate the vast majority of failures attributed to surges and may be purchased at an electronics store. After you have checked all system connections, plug the power cord of the powered Acoustimass module into an AC (mains) receptacle. Your Acoustimass speaker system will turn on and off automatically as it receives a signal from your surround receiver. 12 264887_00 _V.pdf • August 13, 2002