Bose Acoustimass 10 Series III Owner's guide - Page 8
Connecting the speakers
View all Bose Acoustimass 10 Series III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setting Up Connecting the speakers CAUTION: Never connect the cube speakers directly to a receiver output. Always connect them to the powered Acoustimass® module, then connect the module to the receiver. CAUTION: Never use broken or frayed wiring, which can result in electrical shock or damage to your system. The supplied cables are not intended for in-wall installation. Check local building codes or enlist a qualified installer. Connecting front cube speakers to the Acoustimass module Three individual 20-foot (6.1 m) speaker cables connect the center, right, and left front cube speakers to the Acoustimass module (Figure 5). Be sure to match the correct cable with the corresponding speaker location. Front speaker cables have blue RCA connectors at one end with L (left), R (right), or C (center) molded into the connectors. The other ends of the cables have two wires. The red collars on the + wire are labeled LEFT, RIGHT, or CENTER. Figure 5 Cube speaker connections to Acoustimass module RIGHT CENTER LEFT Audio Input Left Center Right Front Front Front Right Rear Audio Output Left Rear RIGHT REAR LEFT REAR 8 264887_00 _V.pdf • August 13, 2002